What is the requirement for the selection of material for die processing

Injection mould processing is the first plastic into the mold, and then die along the heated two vertical shaft continuously rotates and the plastic mold in the gravity and under the action of heat energy, gradually evenly coated, melt adhesion in the die cavity on the entire surface, formed into a desired shape, for cooling and shaping system.



The mold processing in Dalian refers to the processing of the molding tools and the blank making tools, in addition to the shear die and the die cutting die. Normally, the die has two parts: the upper die and the lower die. The steel plate is placed between the upper and lower molds, and the material is molded under the action of the press. When the press is opened, the workpiece determined by the mold shape or the corresponding scrap can be obtained.



Plastic mold factory is that good plastic products are in the selection of prior plastic mold processing, so it is still in use when the products are not on our body and the surrounding environment caused any harm and pollution in production, so they can use the plastic mold processing in chemical industry, food and the furniture inside, can use the plastic mold produced in so many products is because the plastic mold produced in the use of the sealing performance is very good.



The small plastic film produced by mould processing plant is different from the other plastic mold processing materials. The materials selected for processing small plastic mold not only have heat resistance, but also have certain corrosion resistance. The production of relatively small parts on the mold is not to worry about the deformation of the mold due to excessive heat.



Small plastic mold processing than ordinary plastic mould in the design should be more rigorous, because small plastic mold processing are some of the more delicate parts, so small plastic mold processing in the design when the size of the very strict requirements, can not appear a little mistake.