How to control the quality of the product by processing the stamping parts

The main performance of the noise and vibration in the stamping process of two kinds of public hazards, and the operator's safety accidents happen. However, these problems are not entirely due to the stamping process and die itself of Dalian, but mainly due to the traditional stamping equipment and backward manual operation. At present, stamping cattle production enterprises, mainly through the international product inspection to eliminate the unqualified products, so as to control the quality of the final product. This "post inspection" method leads to a waste of time and manpower and material resources. The reason is to ignore the effective control and continuous improvement of J for stamping process.



The stamping process design principles: first, the design of stamping parts must meet with the technical performance of products, and also easy to assemble and repair; then it must be beneficial to improve the utilization of metal materials, reducing materials, varieties and specifications, reduce material consumption as much as possible.



The stamping parts are designed to ensure that they can be used normally, and try to make the requirement of dimensional accuracy and surface roughness level lower, and facilitate the exchange of products, reduce the waste products and ensure the quality of products. The stamping parts designed should be used to make use of the existing equipment, process equipment and process flow as far as possible, and to prolong the service life of the die.