Stamping Parts Into Ultrasound Surface Treatment Equipment

Dalian stamping parts should have enough plasticity, lower yield strength and higher elastic modulus. Among them, the material with good plasticity is not easy to crack, and the material with lower yield strength and higher elastic modulus has smaller resilience. Defects such as scratches can not affect the appearance quality of products, and facilitate stamping, welding, spraying and other follow-up processing.

Drive the worktable and workpiece to move along X and Y direction relative to the electrode wire to complete the processing of plane shape. While the NC device automatically controls the relative trajectory between the workpiece and the electrode wire, the detected discharging gap size and discharging state information are fed back to the digital device after frequency conversion to control the feeding speed. It still has a small part connected with the stamping sheet metal.

Stamping sheet metal with stamped and welded workpiece enters the ultrasonic surface treatment equipment to remove rust-proof grease and welding slag. Eliminate welding beans and burrs in shot peening chamber. Ultrasound surface cleaning technology was used to remove the residues left over from shot peening treatment.

After completing all the above operations, the stamping parts are completely separated from the blank and stored separately. Timely grinding, or it will rapidly expand the wear degree of die edge, accelerate die wear, reduce the quality of stamping parts and die life. Stamping parts are the forming process of sheet metal, strip, pipe and profile by applying external force on press and die to make them produce plastic deformation or separation, so as to obtain the required shape and size of the workpiece (stamping parts).